Driver ID Tag Battery

1. Remove the outer rubber protector by pulling/folding back one side.

2. Take out the inner ID Tag

3. Unscrew the back counter-clockwise.

4. Remove the 2 small screws located on each side.

5. Remove the inner circuit board from the plastic housing.

6. Turn the board over and slide the battery CR2032 out towards the bottom.

7. Place battery CR2032 in the same direction the old battery came out. 8. Put the board back into the plastic casing and screw back in

9. Screw the plastic backing back on clockwise.

10. Insert ID tag back into the protective rubber case

Title